HP CM1312 MFP Series - Manual (Page 140)

If the fax number you are calling has a speed dial or group-dial entry, press Fax Menu , then use
the arrow keys to select Phone Book. Choose Select an entry and use the alphanumeric buttons
to specify the speed dial or group-dial entry, and then press
OK .
6. On the control panel, press Start Fax .
The control-panel display shows the following message: Send from flatbed scanner?.
7. Select Yes.
8. After scanning the page, the product control-panel display shows the following message: Scan
another page?.
9. If you have more pages to scan, select Yes, and then repeat step 3 for each page of the fax job.
-or-
If you are finished, select No.
Fax from the automatic document feeder (ADF)
NOTE: The ADF capacity is up to 50 sheets of 80 g/m 2 or 20 lb media.
CAUTION: To prevent damage to the product, do not use an original that contains correction tape,
correction fluid, paper clips, or staples. Also, do not load photographs, originals smaller than 5x5, or
fragile originals into the ADF. Use the flatbed glass to scan these items.
1. Insert the top-end of the stack of originals into the ADF input tray, with the media stack face-up
and the first page to be copied on top of the stack.
If the media is longer than Letter- or A4-sized paper, pull out the ADF input tray extension to support
the media.
2. Slide the stack into the ADF until it does not move any farther.
Document loaded appears on the control-panel display.
128 Chapter 12 Fax (fax models only) ENWW