Hawking Technology 108G - Manual (Page 57)

57
2.5 QoS
The QoS can let you classify Internet application traffic by source/destination IP address
and port number. You can assign priority for each type of application and reserve
bandwidth for it. The packets of applications with higher priority will always go first.
Lower priority applications will get bandwidth after higher priority applications get
enough bandwidth. This can let you have a better experience in using critical real time
services like Internet phone, video conference …etc. You can adjust the priority of the
rules by moving them up or down.
Note: If the total assigned bandwidth of higher priority applications is larger than the
maximum bandwidth provided by the WAN port, the other applications will not get any
bandwidth.
Parameters Description
Enable/Disable QoS
You can check “Enable QoS” to enable QoS
function for the WAN port. You also can uncheck
“Enable QoS ” to disable QoS function for the
WAN port.
Add a QoS rule into the table
Click “Add” then you will enter a form of the QoS
rule. Click “Apply” after filling out the form and
the rule will be added into the table.
Remove QoS rules from the table
If you want to remove some QoS rules from the
table, select the QoS rules you want to remove