Heat & Glo Fireplace Heat & Glo 350TRSILP-AUF - Manual (Page 23)

23 Heat & Glo • 350TRSI-AUF, 350TRSILP-AUF • 2089-980 Rev. R • 2 /13
D. Mantel and Wall Projections
WARNING! Risk of Fire! Comply with all minimum clear-
ances as specified. Framing or finishing material closer than
the minimums listed must be constructed entirely of non-
combustible materials (i.e., steel studs, concrete board, etc).
Combustible Mantels
Combustible Mantel Legs or Wall Projections
Note: All measurements in millimeters.
Note: Measurement is taken from top of the opening,
NOT the top of the fireplace.
Figure 5.5 Clearances to Mantel Legs or Wall Projections
(Acceptable on both sides of opening.)
Figure 5.4 Minimum Vertical and Maximum Horizontal
Dimensions of Combustibles
Figure 5.6 Non-combustible zone
Figure 5.7
76
152
178
203
229
279
305
51
76
102
127
305
279
254
229
203
178
152
51
102 127
254
TOP FRONT EDGE
OF FIREPLACE
NON-COMBUSTIBLE
BOARD
If joints between the finished walls and the heater surround
(top and sides) are sealed, a 149 ºC (300 ºF) minimum seal-
ant material must be used. These joints are not required to
be sealed. Only non-combustible material (using 149 °C
(300 ºF) minimum adhesive, if needed) can be applied as
facing to the heater surround. See Figure 5.7.
FINISH WALL MATERIAL MAY BE
COMBUSTIBLE - TOP AND SIDES
NON-COMBUSTIBLE
BOARD
HIGH TEMPERATURE (149 ºC (300 ºF MIN.)
TOP AND SIDE SEAL JOINT
Note: Zero clearance finishing allowed on sides of surround
and top of non-combustible board.
3 ft. (914 mm) MAXIMUM
TOP VIEW
2-7/8 in. *
(876 mm)
MINIMUM
1/2 in. *
(13 mm)
MINIMUM
* Add 1/2 in. (13 mm for rear vent)
1/2 in. (13 mm)
SHEETROCK
3-1/2 in.
(89 mm)
1/2 in.
(13 mm)
NON-COMBUSTIBLE ZONE
NON-COMBUSTIBLE
BOARD SHIPPED
WITH APPLIANCE