Heat & Glo Fireplace Heat & Glo 350TRSILP-AUF - Manual (Page 58)

Heat & Glo • 350TRSI-AUF, 350TRSILP-AUF • 2089-980 Rev. R • 2/13
58
Figure 12.7 Mounting Remote Control Housing
AUX300CE Module Installation
• Insert the 4 hole harness from the AUX300CE module into
the 4 pin plug on the control module. See Figure 12.8.
Fan Installation
• Insert the 3 prong plug from the fan into the receptacle
located in the AUX300CE module. See Figure 12.10.
• Insert 3 prong plug from AUX300CE module into REM/
AUX receptacle of fireplace junction cord.
Figure 12.10 Plug Fan into AUX300CE Module
Figure 12.8 AUX 300 module installation
CONTROL MODULE
AUX 300CE
CABLE
AUX 300
MODULE
AUX 1:
3 steps, HIGH,
MED and LOW
AUX 2:
ON/OFF
3 PRONG PLUG (FAN):
3 steps, timer based,
3 min. ON, 12 min. OFF
FAN CORD
Figure 12.10 Programming RC300AU
Programming the RC300AU to the Control Module
CAUTION! Risk of burns! DO NOT program the remote
control to the control module when fireplace is hot.
• Verify the ON/OFF/REMOTE switch is in the REMOTE
position. Green LED light will blink three times and the
control module will beep once 5 seconds later when
ready. See Figure 7.
• Using a small item (such as a paper clip) press and
release the LEARN button located near the ON/OFF/
REMOTE switch. See Figure 12.10.
• Control module will beep once and LED will blink green
for 10 seconds.
• While the LED is blinking, press the POWER button on
the remote control. A double beep will come out of the
control module to indicate that it has been programmed
successfully.
NOTICE: Up to three remote controls can be programmed
into the control module. Simply press a button on the other
remote controls during the 10 second programming process
to add another remote into the system. It is recommended
to program only one RC300AU remote control.
To clear memory in the control module, use a small item
(such as a paper clip) to press and release the LEARN
button. Control module will beep once and LED will blink
green for 10 seconds DO NOT press any buttons on the
remote during the ten seconds that the green LED blinks.
The memory will be cleared. Note that the RC300AU will
not be programmed if it’s in STANDBY mode. Press the
ON/OFF button twice to switch to IDLE mode.
REMOTE POSITION
LEARN BUTTON