Hague Quality Water Intl 63MAQ - Manual (Page 2)

How To Get The Maximum Efficiency From Your Appliance
1. Maintain salt level at least 1/3 full; use
solar salt or pellets and purchase a clean
grade of salt. Use one or the other; do not
mix pellet and solar salt. If potassium
chloride is used in place of nugget or
pellet salt, you must select the potassi-
um option during the programming of
the controller (see pg. 8-12). We do not
recommend using Potassium Chloride if
there is iron and/or manganese in your
water.
2. Allow the appliance to regenerate at a
ti me when the water is not being used. If
you have more than one appliance, allow
two hours between each regeneration.
3. Protect your 60 Series, including the
drain line, from freezing.
4. Should dirt, sand, or large particles be
present in your water supply, it is important
that you consult your Hague dealer for
filters that will eliminate this problem.
5. Bypass the appliance(s) if well, plumbing,
or pump work is required, and turn on out-
side tap until water runs clear before putting
the appliance back in service.
Your 60 Series appliance my be disinfected with 5.25% sodium hypochlorite, which is the
active ingredient in household bleach. To disinfect your appliance, add 4.0 fluid ounces of
sodium hypochlorite solution to the brine well of the brine tank (the brine tank should have
water in it to permit the solution to be carried into the appliance). Start a manual regeneration.
OPERATIONAL, MAINTENANCE, AND REPLACEMENT REQUIREMENTS
ARE ESSENTIAL FOR THE PRODUCT TO PERFORM TO SPECIFICATIONS.
NOTES:
2