Hague Quality Water Intl 63MAQ - Manual (Page 8)

Setting And Using The Appliance Control
Figure 2
SERVICE SETTINGS
This section is recommended for qualified service personnel
only. The appliance control must be set
correctly for proper performance.
FUNCTION: Used to enter SERVICE SETTINGS mode. All
three OPERATING MODES can be selected and all operating
parameters can be set for each OPERATING MODE when this
button is activated.
Press and hold (approximately 3 seconds) until display
changes to "Set language???". Use the NEXT button to step
through parameters that can be set.
REGENERATE
FUNCTION: Multi-purpose. 1.) Used to put the appliance into
an immediate regeneration. Press and hold (approximately 5
seconds) until display changes to "Going to 1". The appliance is
now in regeneration and will return to "Gal. Remain" after com-
pletion of all cycles. 2.) Used to "speed up" or toggle through
all the regeneration cycles.
CUSTOMER SETTINGS/NEXT
This section is recommended for qualified service personnel
only. Must be set correctly for proper performance.
FUNCTION: Multi-purpose. 1.) Used to enter CUSTOMER
SETTINGS mode. 2.) Used to "step" through parameters that
can be set in CUSTOMER & SERVICE SETTINGS modes.
Press and release to accomplish various functions.
SELECT DIGIT
FUNCTION: Used to control cursor movement when in CUSTOMER & SERVICE SETTINGS modes. Used in conjunction
with CHANGE DIGIT button. Press and release the Select Digit button to move cursor one digit to the right of parameter that
can be set. When cursor is at extreme right position, press again to reset cursor to extreme left position.
CHANGE DIGIT
FUNCTION: Used to change values of parameters that can be set. Used in conjunction with SELECT DIGIT button. Press
and release the Select Digit button to move cursor one digit to the right of parameter that can be set. When cursor is at
extreme right position, press again to reset cursor to extreme left position.
SCROLL BACK
FUNCTION: Used to toggle back to the previous parameter setting in the event of a mistake in programming. This feature
eliminates the need to toggle through the entire program to correct an input error.
CONTROL PANEL DISPLAY:
LCD DISPLAY
FUNCTION: Shows status of control; NORMAL OPERATING mode, SERVICE SETTINGS mode or CUSTOMER SETTING
mode. It is very important to know which mode the control is in for proper operation.
WATER FLOWING INDICATOR
FUNCTION: Shown in the LCD display, it indicates that water is flowing through the WaterMax. Flow rate is displayed in
gallons per minute. This is useful for checking for proper plumbing and leaks.
cu5Tt
s
s~rt~as
8