Hotpoint UY46 Mk2 - Manual (Page 33)

33
If something goes wrong...
Before calling a Service Engineer, please check through the following lists.
THERE MAY BE NOTHING WRONG.
Problem
Nothing works.
Display shows 0.00 AUTO.
Main & Top Ovens do not work,
but the Grill works.
Top Ovens and Grill do not work,
but the Main Oven works.
Grill keeps turning on and off.
Can not set an “Auto Cook”
programme
Draught from beneath control
panel.
Timer buzzer/bleeper operates
continually
Check
(a) Check
If you find :-
Display is blank.
Then it is likely that there is no electricity supply to your oven.
Check: (i) That the main cooker wall switch is turned on.
(ii) Check other appliances to see if you have a power cut.
(iii) Check the main circuit breaker for the property.
The power supply to your oven has possibly been interrupted, but
has now come back on again. Reset the timer to the correct time of
day and "Manual" operation using instructions given in the timer
section of the book.
Check the following to ensure that the timer is in Manual Mode:
Check that the Auto Symbol is not lit up and is not flashing.
See timer section for instructions on how to return timer to
"Manual".
Operating the cooker under the following conditions may cause a
safety device to operate.
(a) Grilling with the door closed - always grill with the door open
to the correct position - see grilling.
(b) Grilling for an excessively long period at maximum setting -
see grilling guide.
(c) Grilling with inadequate ventilation in the cabinet - see
installation instructions.
When the "Grill" control (A) is operating at less than MAX, the grill
will cycle on and off, this is normal and is not a fault.
Remember: "Cook Period" is the actual length of time for which, the
timer will switch the oven(s) on as part of an "Auto Cooking"
programme.
A gentle flow of air will be blown from beneath the control panel
when the appliance is used. If the appliance is still warm, this cooling
fan may run on, or restart itself after all of the controls have been
turned off.
The fan will stop once the appliance has been cooled.
This is normal and not a fault.
Press the minute minder button to silence the Buzzer/Bleeper.
If you have been through the above list and there is still a problem, contact Service
(see KEY CONTACTS, back page).