Hanns.G TFT LCD Monitor - Manual (Page 20)

User’s Manual
ERROR MESSAGE & POSSIBLE SOLUTION
CABLE NOT CONNECTED :
1. Check that the signal-cable is properly connected, If the connector is loose, tighten
the connector’s screws.
2. Check the signal-cable’s connection pins for damage.
INPUT NOT SUPPORT :
Your computer has been set to unsuitable display mode, set the computer to display
mode given in the following table.
FACTORY PRESET TIMING TABLE:
VIDEO MODE RESOLUTION
HORIZONTAL
FREQUENCY (kHz)
VERTICAL
FREQUENCY (Hz)
640 Ч 480 31.469 59.94
640 Ч 480 37.500 75.00 VGA
640 Ч 480 37.861 72.81
800 Ч 600 35.156 56.25
800 Ч 600 37.879 60.32
800 Ч 600 48.077 72.19
SVGA
800 Ч 600 46.875 75.00
1024 Ч 768 48.363 60.00
1024 Ч 768 56.476 70.07 XGA
1024 Ч 768 60.023 75.03
1280 Ч 1024 63.981 60.02
VESA
SXGA
1280 Ч 1024 79.976 75.03
640 Ч 350 31.469 70.09
640 Ч 400 31.469 70.09 IBM DOS
720 Ч 400 31.469 70.09
640 Ч 480 35.000 66.67
832 Ч 624 49.725 74.55 MAC
1152 Ч 870 68.681 75.06
20