Hughes Direcway DW6000 - Manual (Page 105)

Appendix B • Installing the indoor equipment using dial-up commissioning
1033295-0001 Revision 2
71
10. Auto cross pol the antenna. When the antenna is locked in
place and continues to pass isolation, finish weather sealing
the coaxial cable connections.
11. Register the DW6000 using Websetup. User should be
present to supply SAN and password and click to agree to
subscriber agreement.
12. After verifying DW6000 has finished downloading, connect
the customer’s PC to it. Customer should use power strip or
surge protector. Customer checks that TCP/IP setting are set
to obtain an IP address automatically and restarts their
computer.
13. Customer verifies connectivity by surfing to a Web site.
14. Record site ID and assigned IP address(es) for the customer
on the Quick Start Guide. Clean up trash and verify
connections are weather proofed. Optional: assist in customer
computer configuration.
15. Complete FSO within 24 hours.
Final installation check
requirements Before leaving confirm the following items:
•
Software Download Status in the User Interface must show
“All files are up-to-date."
• The installer has surfed using the user's computer to at least
the myDIRECWAY site or another Internet site after the
Software Download Status shows "All files are up-to-date."
• The customer’s
System Information page printed out and
the site ID, Gateway ID, and subnet mask recorded on the
Quick Start Guide.Help the customer create a browser
shortcut to the System Control Center. If necessary rename
the shortcut "System Control Center."
• Help the customer download the DW6000 User Guide from
myDIRECWAY.com.