Hughes Direcway DW6000 - Manual (Page 122)

Appendix B • Installing the indoor equipment using dial-up commissioning
88
1033295-0001 Revision 2
7. After the customer enters registration information, write the
information in Figure 74 on the cover of their User Guide.
8. Select Continue in the Registration screen in Figure 74. The
Antenna Pointing - Antenna Location screen appears. See
Figure 75.
9. Verify that the ZIP code shown matches the ZIP code for the
installation site. If not, correct it. Place a check in the
"Enable Self-Hosted Pointing" checkbox and select Next.
The
Antenna Pointing - Receive screen appears. See
Figure 76. At this point it shows no signal strength or auto
cross-pol checkbox.
10. Click through all pointing screens by selecting Next. Click
through until you reach the Websetup - Finish screen. You
will finish registration before peaking the signal.
11. When the Websetup-Finish screen appears, Websetup
receives a parameter file from the WebACS and transfers it to
the DW6000 over the Ethernet connection. If it is successful,
a message appears asking you to press Finish. See Figure 77.
12. Select Finish. The unit is commissioned.
Figure 75: Enter ZIP code
Note: You must not disconnect the power cables before
completing Step 12. Finish registration before peaking the signal
during post-commissioning.