Hughes Direcway DW6000 - Manual (Page 124)

Appendix B • Installing the indoor equipment using dial-up commissioning
90
1033295-0001 Revision 2
Post-commissioning In post-commissioning, you peak the satellite signal, attach the
DW6000 to the customer computer that has a functioning
Ethernet interface, and confirm the customer can surf the Internet.
Peak the satellite signal 1. Unplug the DW6000 power cord from the wall outlet or surge
protector.
2. Remove the phone line from the installer laptop PC.
3. Assemble and install the satellite antenna. This includes
attaching the coaxial cables to the DW6000. Remember to
label the receive and transmit cables.
4. Place the outdoor pointing interface (OPI) in the receive
cable line if applicable.
5. Power on the DW6000. Select Start
→ Programs→ DIRECWAY
Installer
→ Antenna Pointing. The Antenna Pointing - Antenna
Location screen appears. See Figure 78.
6. Verify the ZIP code matches the antenna location and select
Next. The Antenna Pointing - Satellite Parameters screen
appears. Place a check in the Enable OPI Display if you are
using the OPI. Check the satellite Longitude, Hemisphere,
and Frequency values. See Figure 79.
Note: The satellite signal must be peaked for the maximum
signal strength.
Figure 78: Antenna Location; verify ZIP code