Communicating with the dw6000 via hyperterminal, Connection description – Hughes Direcway DW6000 User Manual
Page 137
Appendix C • Installing the DW6000 using Installer Console
1033295-0001 Revision 2
103
Communicating with the
DW6000 via
Hyperterminal
After the DW6000 finishes the LED sequence, you will use a
laptop PC to communicate with the DW6000 via Hyperterminal
through the Ethernet connection. (You can also use a desktop
PC.) You access the Boot Parameters screen and set the
parameters. You also point and cross-pol the antenna. In order to
complete the parameters, you will need your installer ID and the
information shown in Figure 102 on page 109.
1. Connect to the Installer Console with Hyperterminal.
a. Launch HyperTerminal. The
Connection Description
window appears. See Figure 94.
b. Type
DW6000
in the
Name
field and click OK. The
Connect To
window appears. See Figure 95.
– Enter
192.168.0.1
in the
Host address
field.
– Enter
1953
in the
Port number
field.
– Click on the
Connect Using
pull-down menu and select
TCP/IP (Winsock)
.
c. Click OK. If the DW6000 unit is connected to your PC via
Ethernet the Main Menu appears in the HyperTerminal
window.
Figure 94: Connection Description