Hughes Direcway DW6000 - Manual (Page 144)

Appendix C • Installing the DW6000 using Installer Console
110
1033295-0001 Revision 2
3. When you have entered all parameters, return to the Main
Menu and enter pw . This saves the configuration parameters
to the flash memory. At this point, depending on the
parameters that were modified, the DW6000 may reset.
4. A message Writing the configuration -are you
sure (y/n) appears. Enter y . At this point, depending on
the parameters that were modified, the DW6000 should reset.
If it does not reset, enter
rr to do a DW6000 reset.
5. At the Main Menu prompt, enter b to display the current
configuration. The display is similar to the one shown in
Figure 102. Verify the parameter values and match them to
the installation or NOC specification.
The Installation Menu After you have entered the boot parameters, use the Installation
Menu to receive and transmit point the antenna. Transmit
pointing uses both an automatic and manual mode.
The Outdoor Pointing Interface (OPI) device can also be used to
point an antenna used with a DW6000. Follow the instructions in
the Outdoor Pointing Interface Operating Instructions (HNS
1031832-0001).
Note: Remember that if you use the OPI, the LNB 22KHz
Switch parameter must be set to "OFF." You may leave the
parameter set at "OFF" for the rest of the installation.
Note: Remember that if you wish to exit the Installation Menu
and return to the Main Menu, you must type "Z" and press
E NTER . If you don’t you’ll remain in one of the Installation
submenus until you do so.