Sbc installation method, Caution – Hughes Direcway DW6000 User Manual

Page 37

Advertising
background image

Chapter 2 • Installing the indoor equipment

1033295-0001 Revision 2

13

SBC installation method

First assemble and install the satellite antenna. This includes
attaching the coaxial cables to the DW6000 Satellite In and
Satellite Out connectors. Remember to label the receive and
transmit cables. Because the entire commissioning process will
be done over the satellite, the receive and transmit cables must be
connected from the satellite antenna to the DW6000.

Then follow the steps below and refer to the illustrations on
page 14 through page 16 to install the DW6000. .

Note:

Before beginning the installation, confirm that your

laptop’s TCP/IP settings are configured to "Obtain an IP address
automatically." See Appendix D – on page 115

CAUTION

Do not connect the power supply to the DW6000, or connect
the power supply to a power source, before instructed to do
so.

CAUTION

• Do not block any ventilation openings. Do not install near

any heat sources such as radiators, heat registers,
ovens, stoves, or other apparatus (including amplifiers)
that produce heat.

• Recommended ventilation space around the top and

sides of the DW6000 assembly should be approximately 6
inches. Ventilation is necessary to avoid overheating.

Advertising