Hughes Direcway DW6000 - Manual (Page 70)

Chapter 3 • The System Control Center
46
1033295-0001 Revision 2
Transmission Info The Transmission Info screen displays the fields described
below.
•
Transmit status - reports the status of the transmit data path.
Clicking on the blue status message displays corresponding
help information.
•
Number of successful transmissions- reports the number of
frames transmitted to the satellite.
•
Number of failed transmissions- reports the number of frames
that could not be sent. A continuously increasing value
indicates a problem with transmitting. However, if a low
nonincreasing value is displayed and the system is
functioning, there is no reason for concern. You do not need
to do any troubleshooting or contact installer support.
•
Number of packets submitted for transmission- indicates total
number of data queued for transmission to the satellite..
Transmit messages The following messages may appear in the Transmit field. The
Comments section gives more information about each code, and
describes any possible corrective measures. See Figure 49 on
page 45 for corrective measure involving cables or the power
supply. Power cycling means to unplug the power cord from the
wall outlet or surge protector, wait 10 seconds, and plug it back
in.
If corrective measures do not solve a problem, contact installer
support.
TxCode 8 means the transmit is working properly. It is the code
you will see most of the time.
Figure 50: Transmission Info screen