Honeywell 9900 - Manual (Page 87)

Dolphin® Power Tools User’s Guide Rev A
8/6/08
5 - 9
AimerDuration The number of milliseconds the
scanner aimer is displayed, after the
trigger key has been pressed down,
before attempting to decode a
barcode. 0
[Decode
begins
instantly.
]
Enter times in 1/1000th of a
second.
AimerDelay The amount of time between scans
before the aimer turns on again. 500
AimerDurationALR The amount of time the aimer stays
on. This setting is for an ALR
decoder. 2000
AimerDelayALR The amount of time between scans
before the aimer turns on again.
This setting is for an ALR decoder. 500
DefaultEnabledSymbo
logies Specifies which symbologies should
be enabled before processing the
Symbologies section.
See Symbologies Section on page 5-
17.
0 0=Use internal list
1=All symbologies are disabled
initially. Enable specific
symbologies in the
Symbologies section.
2=All symbologies are enabled
initially. Disable specific
symbologies in the
Symbologies section.
EnablePrefixData Enables or disables all prefix data
received from the decoder after a
successful scan.
All prefix data is defined in the
Settings Section (see page 5-3).
1 0=Disabled
1=Enabled
EnableSuffixData Enables or disables all suffix data
received via decoder after a
successful scan.
All suffix data is defined in the
Settings Section (see page 5-3).
1 0=Disabled
1=Enabled
Decode Section
The Decode section specifies decoder settings when using the decoder with ScanWedge.
ScanWedge Entry Description Default
Value Available Values