Honeywell HCE 60 - Manual (Page 46)

Assigning zones and issuing room names
44
Resetting storey controller to state of delivery
All current assignments are lost if the storey controller is reset
to the state of delivery. The storey controller retains its con-
figuration after a power failure.
► Pull out the connector of the storey controller.
► Keep the buttons and at the storey controller pressed at the
same time and plug in the connector again.
The
and LEDs illuminate. The LED of zone 1 is red.
► Press the installation button briefly.
The LED of Zone 1 is extinguished. The LED of zone 2 is illumi-
nated.
► Press the fault button .
► Pull the connector of the storey controller again and plug it in again.
The storey controller is reset to the state of delivery.
Note to installer
After the storey controller has been started up, you should inform your
customer about the Hometronic system:
► Familiarize your customer with the operation of the Hometronic.
► Explain the manual operation of the components.
► Point out particular features and extension possibilities of the re-
spective customer installation.