HONDA FL5540K0 - Manual (Page 14)

ASSEMBLY INFORMATION
ASSEMBLY INFORMATION
GENERAL
Read assembly instructions completely prior to installing loader to familiarize yourself with all
mounting and hydraulic system installation procedures.
The loader operates from its self contained hydraulic system with the pump driven from the
tractor front PTO.
A pipe thread sealant must be used on all pipe threads.
All hardware required for mounting loader is supplied.
Loader mount component hardware should be left loose until all mount components have been
installed.
Unless otherwise specified, refer to torque specification table for torque values of hardware
required for assembly.
Lay out and identify all components to installation.
TORQUE SPECIFICATIONS
AMERICAN
Bolt Head Markings
Grade 2
(No
SAE Grade 5
METRIC
Numbers appearing on bolt heads
indicate ASTM class.
Proper torque for American fasteners used on Honda equipment
Recommended Torque in Foot Pounds (Newton Meters).
Use 75% of the specified torque'value for plated
fasteners. Use 85% of the specified torque values
for lubricated fasteners;
Proper torque for metric fasteners used on Honda equipment.
Recommended Torque in Foot Pounds (Newton Meters).
I
CLASS
8.8
CLASS CLASS
ASTY ASTY ASTY
5
93 73 74 25 12
42 14.5 10
27 21.1 7.3 8
11.1 8.7 3 6
6.5 5.1 1.8
12