Honeywell HRXD9 - Manual (Page 56)

Configuration
56
Note If the DVR is configured for DHCP or an ADSL network, the
DVR’s IP address might change whenever the unit is turned on.
Modem Setup
1. Highlight the Modem tab, and the Modem screen ( Figure 3-29 ) displays.
Figure 3-29 Modem Setup Screen
Note If the RS232 port is in use for remote control, networking cannot
be configured for a modem.
2. Highlight Enable and press to toggle between On and Off. You will only be
able to change the settings if Modem is enabled.
3. Highlight the box beside Baud Rate and press . A list of baud rates ranging
from 300 to 115,200 appears.
4. Highlight the box beside Data Bit and press . Choose between 7 bit and 8 bit
formats.
5. Highlight the box beside Stop Bit and press . Choose between 1 and 2 Stop
Bits.
6. Highlight the box beside Parity and press . A drop-down list appears. You can
select from None, Odd or Even parity.