Honeywell HD28D4HR6 - Manual (Page 7)

Rev 1.01 2 Document 900.0275
10/05
Installation
Your HD28 camera is weather-sealed for indoor or outdoor locations. The wiring
can be completely concealed for maximum vandal and tamper resistance.
Mounting the Camera
The HD28 camera is designed to be surface mounted on a wall or ceiling.
Preparing the Mounting Surface
1. Affix the mounting template to the mounting surface (see Figure 1 ).
2. Pre-drill four holes as indicated on the template, using the recommended
hole size for the screws being used.
3. Drill out the conduit hole, if required (see Installing the Conduit Plug ).
4. Connect the wiring (see Connecting the Wiring ).
5. Mount the camera base to the wall or ceiling using mounting screws (not
supplied) capable of holding at least twice the weight of the camera.
Note Alternate fasteners (preferably stainless steel) can be used, provided
they are not larger than the screw holes on the mounting template.
Figure 1 Mounting Template Guide
Wal
l Mo
unt
reco
mm
end
ed
this
wa
y
Mounting screws
appropriate to your
installation (not
supplied)