HONDA HHT25S - Manual (Page 7)

7
CONTROLS AND EQUIPMENT
COMPONENT CONTROLS AND LOCATIONS
Loop Type Handle
U-Type Handlebar
This type is supplied with a cutting-line head, a saw blade, and two
debris shields.
Engine
CONTROLS
The location and operation of the controls are similar on both the
HHT25S and HHT35S models.
Choke Lever
The choke lever opens and closes the choke valve.
The CLOSED position enriches the fuel mixture for starting a cold
engine.
The OPEN position provides the correct fuel mixture for operation
after starting, and for restarting a warm engine.
Ignition Switch
The ignition switch controls the ignition system.
The ignition switch must be in the ON (I) position for the engine to
start and run.
Moving the ignition switch to the STOP (O) position stops the engine.
Operator Presence Lever
The operator presence lever blocks the throttle trigger. This safety
feature prevents unintentional throttle operation if the trimmer is
bumped while the operator’s hand is not on the control handle.
When the operator presses the presence lever by gripping the control
handle, the trigger moves freely.
HARNESS HANGER
DEBRIS SHIELD
WITH CUTOFF KNIFE
DRIVE CABLE
FRAME PIPE
LOOP HANDLE
THROTTLE SET BUTTON
OPERATOR
PRESENCE
LEVER
THROTTLE
TRIGGER
IGNITION SWITCH
CUTTING-LINE HEAD
GEAR CASE
GEAR CASE
IGNITION SWITCH
THROTTLE
TRIGGER SAW BLADE
OPERATOR
PRESENCE
LEVER
HARNESS
HANGER
DRIVE CABLE
FRAME PIPE
U-TYPE
HANDLEBAR
THROTTLE
SET BUTTON
DEBRIS SHIELD
FOR BRUSH/
WOOD BLADE
SPARK PLUG
AIR
CLEANER
COVER
PRIMING
BULB
OIL FILLER CAP
STARTER
GRIP
SPARK
ARRESTER
FUEL RETURN
TUBE (CLEAR)
FUEL SUPPLY
TUBE (BLACK)
FUEL TANK CAP
CHOKE LEVER
CHOKE LEVER
CLOSED
OPEN
U-type Handle: Loop Handle:
STOP
(O)
ON (I)
STOP (O)
ON (I)
IGNITION
SWITCH
OPERATOR
PRESENCE
LEVER
IGNITION
SWITCH
OPERATOR
PRESENCE
LEVER