Honeywell BENDIX/KING KLN 94 - Manual (Page 11)

B
KLN 94
Rev. 4, Jan/2003 10599I04.CDL Page 1-1
SECTION I
GENERAL INFORMATION
1.1 INTRODUCTION
This manual contains information relative to the physical, mechanical, and electrical
characteristics of the BENDIX/KING KLN 94 Global Positioning System (GPS) Receiver. General
installation procedures are also included.
1.2 EQUIPMENT DESCRIPTION
The KLN 94 is a panel mounted, long range, GPS based airborne navigation system with a
database. The KLN 94 also provides VFR, IFR enroute, and IFR non-precision approach
functions. The primary purpose of the equipment is to provide the pilot with present position
information and to display guidance information with respect to a flight plan defined by the pilot.
Flight plan information is entered by the pilot via various knobs and buttons on the front panel.
The unit can use its present position information to determine crosstrack error, distance to
waypoint, ground speed, track angle, time to waypoint, bearing to waypoint, and advisory VNAV
guidance. The database of the KLN 94 contains information concerning airports, VORs, NDBs,
intersections, DP/STARs, outer markers, roads, rivers, railroads, lakes, etc., throughout the
database’s coverage area. Waypoints are stored in the database by their ICAO identifiers. The
ICAO identifiers are in most cases taken directly from Jeppesen Sanderson or government
aeronautical charts. The KLN 94 has instrument approach capabilities.
The information stored in the database eventually becomes out of date; therefore, to provide a
means of updating the information, the database is housed in a data card which plugs into the
front of the KLN 94. It is designed so that the user may easily remove the old database and install
a current database. A secondary method of updating the database is by loading the information
via an IBM compatible laptop computer. For more information on availability and cost of updating
the database of the KLN 94, refer to the KLN 94 Pilot’s Guide P/N 006-18207-0000.
1.3 TECHNICAL CHARACTERISTICS
1.3.1 KLN 94 TECHNICAL CHARACTERISTICS
TSO/JTSO Compliance: TSO-C129a, JTSO-C129a - See Appendix C
for environmental qualification.
Physical Dimensions: Refer to KLN 94 installation drawing, Figure
2-5
Mounting: Panel mounted with Honeywell supplied
mounting rack
Cooling Requirements: 4 CFM (cubic feet per minute) provided by
blower motor such as KA33 or equivalent.
Temperature Range: -20°C to +55°C
Altitude Range: Up to 55,000 Feet