Honeywell BENDIX/KING KLN 94 - Manual (Page 81)

B
KLN 94
Rev. 4, Jan/2003 10599I04.CDL Page 2-77
2.4.4.6 Moving Map Interface
If the KLN 94 is interfaced to a moving map display, verify operation by moving the aircraft out to
an open location to acquire a satellite position. Enter an active flightplan or active waypoint to
develop a presentation on the map.
Some moving maps require 2 kts of ground speed to display, as the sense track angle is used
instead of the heading. The KLN 94 does not output track angles when the groundspeed is below
2 kts.
2.4.4.7 External Annunciators
Recycle the power on the KLN 94 which will cause the Self Test Page to be displayed. Verify that
all external annunciators are energized. Cycle the KLN 94 display past all initialization pages.
Verify all external annunciators are extinguished. If the message light comes on, view the
Message Page to verify that there is a message. If any other annunciator remains lighted, review
the status of the KLN94 to determine if the lighted annunciator is justified.
NOTE
Annunciators should be checked one at a time in order to verify that the correct
one lights.
2.4.4.8 Quicktune

Interface
If the KLN 94 is interfaced to a KX 155A / KX 165A for Quicktune

operation, the following test
must be performed to verify the installation. Turn on the KLN 94 and display the APT5 page,
where airport frequencies are displayed. choose any airport with at least one frequency. Press
the CRSR button, move the cursor on any frequency and press the ENT button. Verify that the
selected frequency now appears in the COMM Standby Frequency of the KX155A / KX165A. To
verify the NAV part of the operation, display the VOR1 page. Press the CRSR button, move the
cursor on the VOR frequency and press the ENT button. Verify that the selected frequency now
appears in the NAV Standby Frequency of the KX 155A / KX 165A.
2.4.4.9 Dataloader
The database cartridge may be updated with a new navigation database using a laptop
computer. The laptop computer must be IBM compatible and have an available COM port (1, 2, 3,
or 4).
Internet Update
A new navigation database can be obtained via the Internet at the following address:
http://www.gpsdatabase.com
Store the new database on the hard drive of the PC. Then connect the laptop via the PC loader
kit PN 050-03612-0000 (refer to
Figure 2-26 ). Turn on the KLN 94 to the SET 3 page. Then run
the program NETLOAD.EXE and follow the appropriate instructions.