Honeywell Central Heating Cooker Natural Gas - Manual (Page 7)

7
USERS INSTRUCTIONS
COOKER BURNER
5.1 The cooker burner is fully automatic and requires no manual
intervention to light. Ensure that the programmer is in the
ON mode, neon glowing, and turn the thermostat to the
desired temperature. The cooker light will illuminate and once
the desired temperature has been reached it will extinguish.
BOILER BURNER
5.2 The boiler burner is fully automatic in operation and requires
no manual intervention to light. Ensure that any external
controls are on and calling for heat and that the thermostat is
turned on to the desired temperature. The boiler light will
illuminate and once the desired temperature has been
reached it will extinguish.
Please note the section on frost protection. (page 1)
6.1 For short periods: Turn all the external controls to off and
turn the boiler thermostat to ‘off’. Turn the cooker thermostat
to ‘off’ and switch the cooker programmer to off.
6.2 For Long Periods: Turn all external and internal controls to
off, switch off the electrical supply to the unit.
6.1 In general the programmer is used either to turn ‘On’ of
‘Off’ the cooker manually or automatically.
Programmer Setting instructions
6.2 On initial power-up the unit should be re-set to wake up the
unit remove the programmers button cover, see figure 2. To
re-set the unit press and hold the four buttons shaded grey,
see diagram 1.
6.3 Figure 2 depicts how the display will look after being re-set.
Factory programming.
6.3 The unit can provide up to 3 On/Offs each day.
In order to simplify programming a factory pre-set
programme is included. This can be easily altered to suit
household lifestyle and needs.
Event 1 ON = 06:30 AM OFF = 08:30 AM
Event 2 ON = 12:00 PM OFF = 02:00 PM
Event 3 ON = 05:00 PM OFF = 10:30 PM
Setting the time of the day.
6.4 Remove the programmers button cover.
6.5 Press PROG to enter programming mode. The display will be
as in diagram 3 and the colon in the display will not flash.
6.6 Press and release the + or - button to change the time in
one minute increments. Note: If the button is held down, the
time will change in increments of 10 minutes.
5. LIGHTING THE BURNERS
6. SWITCHING OFF
7. PROGRAMMER -COOKER
SELECT PROG
ADV
1 HR
1
SELECT PROG
ADV
1 HR
ON
OFF
AUTO
ALLDAY
+ 1 HOUR
ADVANCE
Unit with programming cover removed
2
ON
OFF
AUTO
ALLDAY
+ 1 HOUR
ADVANCE
3