Replacing your bulbs, Mercury notice – Honeywell UC100 User Manual

Page 2

Advertising
background image

UC100 ULTRAVIOLET SYSTEM REPLACEMENT BULB/HANDLE ASSEMBLY

69-1444—5

2

MERCURY NOTICE

This device contains mercury in the sealed ultraviolet

bulb(s). Do not place your used bulb(s) in the trash.

Dispose of properly.

Broken Bulb Cleanup.

Do not use a household vacuum.

Sweep debris (phosphor/glass) into a plastic bag and

dispose of properly.

Contact your local waste management authority for

instructions regarding recycling and the proper

disposal of old bulb(s).

Replacing Your Bulbs

SmartLamp™ Models (UV100E1043, UV100E2009,
and UV100E3007)

Replacement of your bulbs is required when LED on front of

unit is lighted solidly.

NOTE: LED blinking slowly, one second on and one second

off, indicates that ten percent or less of bulb life

remains and homeowner must order new bulb(s).

IMPORTANT

Remember to press the reset button for five seconds

after replacing the bulb(s).

UV100A1000, UV100A1018, UV100A1026,
UV100A1059, UV100A2008, UV100E1001,
UV100E1019, UV100E1027, UV100E1035 Models

Annual replacement of your bulbs is required.

To replace your bulbs:

1. Select and obtain the correct replacement bulb for your

unit. See Table 1.

2. Disconnect the power to your heating and cooling

system.

3. Unplug or turn off power to your UV System and allow

the bulbs to cool for at least 15 minutes.

4. Rotate the lamp handle counterclockwise and gently

pull the lamp handle to remove the bulb. See Fig. 1.

IMPORTANT

If the bulb in your model has external wires running

along the glass surface, be sure to avoid pulling on

those wires.

Fig. 1. Remove lamp bulb.

5. If you have a SnapLamp™ handle, follow steps 5 and 6;

otherwise, proceed to step 7. Grasp the SnapLamp™

handle in one hand and the bulb glass in the other and

pull straight apart. See Fig. 2.

Fig. 2. Disconnect bulb from SnapLamp™ handle.

6. Insert the new bulb into the SnapLamp™ handle by

aligning the notch and pushing straight together.

See Fig. 3.

Fig. 3. Replace bulb in SnapLamp™ handle.

7. Insert the lamp handle into the base with the lamp light

indicator at the eleven o’clock position. Continue

pushing and gently rotating counterclockwise until the

lamp inserts fully into the base. See Fig. 4.

M22841

M22851

M22853

Advertising