Honeywell DCP552 Mark II - Manual (Page 122)

7-23
[Note:]
CH2 PID parameter settings are described on this page. CH2
PID parameters are set when the PID key is pressed when
CH2 is selected (when the EG2 LED is on) during program
operation in the normal display mode.
0 d-A5 81 Derivative time (PID group A5)
4500 SPU tP-A5 84 Tuning point (PID group A5)
5000 SPU CP-A5 83 Changeover point (PID group A5)
50.0 rE-A5 82 Manual reset (PID group A5)
100.0 P-A6 85 Proportional band (PID group A6)
0 I-A6 86 Integral time (PID group A6)
0 d-A6 87 Derivative time (PID group A6)
50.0 rE-A6 88 Manual reset (PID group A6)
6000 SPU CP-A6 89 Changeover point (PID group A6)
5500 SPU tP-A6 90 Tuning point (PID group A6)
100.0 P-A7 91 Proportional band (PID group A7)
0 I-A7 92 Integral time (PID group A7)
0 d-A7 93 Derivative time (PID group A7)
50.0 rE-A7 94 Manual reset (PID group A7)
20000 SPU
(fixed)
CP-A7 95 Changeover point (PID group A7)
6500 SPU tP-A7 96 Tuning point (PID group A7)
Item code Item No.
User
settings
Settings and descriptions
Factory default
settings
Chapter 7. PARAMETER SETUP