Honeywell DCP552 Mark II - Manual (Page 128)

7-29
0 to 127
[Description:]
Т----У is displayed for model without communications and
when C97 is set to a value that is not equal to 0 and
setting cannot be performed.
When C76 is set to 0, the communication function is not
activated.
0 C 76 76 Communication address
0: 9600bps
1: 4800bps
2: 2400bps
3: 1200bps
[Description:]
Т----У is displayed for model without communications and
when C97 is set to a value that is not equal to 0 and
setting cannot be performed.
0 C 77 77 Transmission rate
0: 8 bits, even parity, 1 stop bit
1: 8 bits, no parity, 2 stop bits
[Description:]
Т----У is displayed for model without communications and
when C97 is set to a value that is not equal to 0 and
setting cannot be performed.
0 C 78 78 Transmission code
0: CPL
1: ST221 (no PV trend)
2: ST221 (PV trend)
[Description:]
Т----У is displayed for model without communications and
when C97 is set to a value that is not equal to 0 and
setting cannot be performed.
0 C 79 79 Communication
0 : RS-485
1 : RS-232C
[Description:]
Т----У is displayed for model without communications and
when C97 is set to a value that is not equal to 0 and
setting cannot be performed.
0 C 80 80 Communication method
[Description:]
Can only be referenced for mechanical service use.
Ð C 81 81 ROM ID
Ð C 82 82 ROM ITEM
Ð C 83 83 ROM revision
Ð C 85 85 CPU board ID
Ð C 86 86 I/O board ID
[Description:]
Т-----У is displayed and setting cannot be performed.
---- C 87 87 Unused
---- C 88 88 Unused
---- C 89 89 Unused
1 C 90 90 PID type
0: Yes
1: No
0 C 91 91 PV1 burnout
0: Yes
1: No
0 C 92 92 PV2 burn out
0: Does not go on a second time off in time proportional cycle.
1: Goes on a second time in time proportional cycle.
0 C 93 93 Time proportional output
0: Does not go on a second time off in time proportional cycle
1: Goes on a second time in time proportional cycle
0 C 94 94 Time proportional output
Ð C 84 84 Data version
Item code Item No.
User
settings
Settings and descriptions
Factory default
settings
2 to 22mA
2 to 22mA 15 C 95 95 Voltage output control (CH1)
15 C 96 96 Voltage output control (CH2)
0 to 15
The backplate terminal is used when set to 0.
The loader jack is used for settings 1 to 15.
[Description:]
When set to 0, communications cannot be performed on
model without communications.
When set to 0, communications conditions are selected
using C76 to C80 .
The communication address is used for settings 1 to 15.
4800bps, 8 bits, even parity, 1 stop bit
0 C 97 97 Communications port
0 to 255
[Description:]
A setting of 0 is normally used.
0 C 98 98 Special function
0: Improved
1: Compatible with MarkI
Chapter 7. PARAMETER SETUP