Honeywell DCP552 Mark II - Manual (Page 198)

12-8
■ Function test
Press ↑ , ↓ , ← , → , keys to show (
0.0.0.0
) on upper display, then press ENTER
key .
● Key test (00-01)
Press SETUP key until the PROG/SEG display shows ( 00-01 ).
When you press each key, the data appears in the upper display (shown in Table
12-3) and in the lower display (shown in Table 12-4).
Table 12-3. Upper Display
Table 12-4. Lower Display
Handling Precautions
1. When you press DISP key, calibration mode will be exited.
2. When you press SETUP key, the next calibration menu will be entered
(Display test).
2.0.0.0.
1.0.0.0.
Key Data
4.0.0.0.
0.8.0.0.
Key Data
0.4.0.0. 0.2.0.0. LOAD SAVE
2.0.0.0
0.2.0.0.
0.4.0.0.
0.0.4.0.
0.0.2.0
Key Data
1.0.0.0.
0.8.0.0.
0.0.1.0.
0.0.0.8.
0.0.0.2.
Key Data
ENTER
CLR
PARA
FUNC
PID
A/M AT
PROG
MESSAGE
RUN/HOLD
Chapter 12. CALIBRATION