Key chord functions – Honeywell DCP552 Mark II User Manual

Page 21

Advertising
background image

2-6

Key chord functions

PROG + RUN/HOLD

:

Reset key

Press the

RUN/HOLD key

while holding down the

PROG key

in basic status

display to perform a RESET.

The READY mode is invoked when a reset is performed in the RUN, HOLD,

FAST, END, or READY FAST modes. This RESET operation does not work

in the READY mode.

PROG + DISP

:

Advance key

Press the

DISP key

while holding down the

PROG key

in the program run mode

in basic status display to perform an ADV (advance) operation. The next segment

is displayed when this action is performed in the RUN, HOLD, FAST, or

READY FAST modes. This ADV operation does not work in the READY mode.

FUNC +

:

Fast key

Press the

key

while holding down the

FUNC key

in the program run mode

in basic status display to perform a FAST operation.

The system changes from the RUN or HOLD mode to the FAST mode. If the

system is in the READY mode, it goes to the READY FAST mode.

Chapter 2. NAMES AND FUNCTIONS OF PARTS

Classification

Program setting

Program copy

General reset

Memory card

operation

Erases or resets a set value.

(When a set value flickers.)

Key operation

FUNC + CLR

Cancels change in set value.

(When a set value flickers.)

DISP

FUNC + ENTER

Inserts or delete a segment when a pattern SP setting is started.

FUNC + PROG

Changes RAMP-X « RAMP-T or RAMP-X « RAMP-E when a

pattern SP setting is completed.
Starts a program number change.

DISP

Ends program setting.

­ + PROG

Starts program copy. (In basic display status)
Changes program number at copy destination.

ENTER

Executes the copy.

(When a set value flickers.)

DISP

Ends program copy.

SAVE

Starts a data write operation to the memory card.

(In basic display status)
Writes data to the memory card.

LOAD

Starts a data read operation from the memory card.

(In basic display status)
Reads data from the memory card.
Changes selected memory card operation.

ENTER

Enters memory card operation.

DISP

Interrupts memory card operation.

FUNC + CLR + MESSAGE

Returns a check status of the general reset. (In basic display status)

ENTER

Executes a general reset.

DISP

Interrupts a general reset.

Function

­ ¯

­ ¯

Advertising