Honeywell DCP552 Mark II - Manual (Page 27)

3 - 2 Installation
This section describes installation procedures.
■ Panel cutout dimension
Use 2mm thick steel panels in setting up the DCP552 .
Handling Precautions
Install the DCP552 in a location where the lower panel is not exposed to
temperatures that exceed the operating temperature range (0 to 50°C).
Make sure that the temperatures above and below the controller meet
specified requirements.
3-3
Chapter 3. INSTALLATION AND MOUNTING
200 or more
450 or more
138
+1
0
138
+1 0
Unit : mm