Honeywell DCP552 Mark II - Manual (Page 60)

5-14
•Program/segment number event
A program or a binary coded segment number is set in an event type and the
number of output points (1 to 7) is set in auxiliary setting 1. Or a program or a
BCD code of the segment number is set in an event type and the number of output
points (1 to 8) is set in auxiliary setting 1.
A selection, a program designed for a specific operation or a coded segment
number is output. A low-order bit code corresponding to the set number of output
points is output.
•An event on delay can be combined with the code event.
Note, however, that when there are several channel code events, the delay has to
be entered for each channel.
Chapter 5. FUNCTIONS
Decimal
1
Binary code output
(0: Off output 1: On output)
0 0 0 0 0 0 1
2 0 0 0 0 0 1 0
3 0 0 0 0 0 1 1
4 0 0 0 0 1 0 0
5 0 0 0 0 1 0 1
6 0 0 0 0 1 1 0
7 0 0 0 0 1 1 1
8 0 0 0 1 0 0 0
9 0 0 0 1 0 0 1
10 0 0 0 1 0 1 0
11 0 0 0 1 0 1 1
12 0 0 0 1 1 0 0
13 0 0 0 1 1 0 1
14 0 0 0 1 1 1 0
15 0 0 0 1 1 1 1
16 0 0 1 0 0 0 0
17 0 0 1 0 0 0 1
¥
¥
¥
Decimal
1
BCD code output
(0: Off output 1: On output)
0 0 0 0 0 0 0 1
2 0 0 0 0 0 0 1 0
3 0 0 0 0 0 0 1 1
4 0 0 0 0 0 1 0 0
5 0 0 0 0 0 1 0 1
6 0 0 0 0 0 1 1 0
7 0 0 0 0 0 1 1 1
8 0 0 0 0 1 0 0 0
9 0 0 0 0 1 0 0 1
10 0 0 0 1 0 0 0 0
11 0 0 0 1 0 0 0 1
12 0 0 0 1 0 0 1 0
¥
¥
¥
20 0 0 1 0 0 0 0 0
30 0 0 1 1 0 0 0 0
40 0 1 0 0 0 0 0 0
50 0 1 0 1 0 0 0 0
¥
¥
¥
Decimal binary code comparison table Decimal BCD code comparison table