Honeywell DCP552 Mark II - Manual (Page 72)

5-26
■ Mode transitions
● Program operation
Mode transitions are indicated by the solid line arrows and end operation is
indicated by the dashed lines in the figure below.
NOTE
•AUTO ↔ MANUAL mode changes can be made in the boxes of each mode.
•READY and END at the end of operation can be selected using setup data
C31 .
•CH1 and CH2 mode transitions can be performed both synchronously or
asynchronously.
● Constant value control
Mode transitions are indicated by the solid line arrows.
NOTE
•AUTO ↔ MANUAL mode changes can be made in the boxes of each mode.
•CH1 and CH2 mode transitions can be performed both synchronously or
asynchronously.
● Switching between program operation and constant value control
Constant value control data “ ConSt ” control mode item in the READY mode is
used to switch between these two modes.
0: Program operation
1: Constant value control
Chapter 5. FUNCTIONS
END AUTO
END MANUAL READY AUTO
READY MANUAL RUN AUTO
RUN MANUAL HOLD AUTO
HOLD MANUAL RESET
RUN
RESET
HOLD
RUN
READY FAST AUTO
READY FAST MANUAL FAST AUTO
FAST MANUAL
ADV
RESET ADV ADV
FAST RESET
FAST FAST
HOLD RUN
RESET
RUN
ADV ADV
READY AUTO
READY MANUAL RUN AUTO
RUN MANUAL
RUN
RESET