Assembly – Harman Stove Company 828i User Manual
Page 7
7
Assembly
The Clarity 828I Fireplace Insert comes with the
log set packed inside the firebox. The three trim
panels and two wing brackets are packed together
in a separate carton. NOTE: The wing brackets
must go on before the door.
A second shipping carton contains the wing
panels. Two different size wing panel sets are
available for the Clarity Insert: large (32-1/2" X
44"), and small (30" X 40"). The set that will work
best with the fireplace opening should be used.
The wing panels may be trimmed to fit inside the
fireplace opening if a flush look is desired.
Before the unit is installed, all components
should be unpacked. The cross log must be re-
moved, the packing material taken out, and then
re-installed.
The Clarity 828I is shipped from the factory
equipped to burn either natural gas or propane. If
the alternate fuel is to be used, the appropriate
burner system module must be installed at this
time as well. See the fuel conversion instructions in
Appendix A on page 15.
Removing the Glass door
NOTE: The glass door is heavy. Be prepared for
its weight when lifting it to avoid damage during
removal.
Locate latches on each side of the glass door.
Then, grasp each latch handle and pull forward
until the front is disengaged. Lift the glass door
slightly and remove it
from the stove. Set the
glass door aside in a
safe place where it
will not be damaged.
WARNING: Do not
abuse the glass on the
Clarity Fireplace
Insert front by strik-
ing, slamming, or
similar trauma. Do
not operate this
Fireplace Insert with
the glass panel re-
moved, cracked or
broken. Use only glass
supplied by Harman and approved for use with
this heater. Do not use substitute materials. Re-
placement of the panel should be done by a li-
censed or qualified service person.
Removing and Replacing logs
The log set consists of a back log (1), a center log
that has a pilot-viewing port in the left end (2),
ember strip (3), and a cross log that rests on top
(4).
Remove the cross log, the center log, and the
ember strips, in that order. To remove the rear log,
first pull the fuel system module forward about an
inch to create clearance, then lift the log out.
Re-install the logs in the same order that they
were removed. Place the rear log in position first,
centered and pushed snugly against the back wall,
and slide the fuel system module back into posi-
tion.
Re-install the ember strips so that they rest
against the front of the firebox. Guide them to-
ward you and to the outside until they fit snugly.
Check the air slot in the inside of the ember strips
to confirm that they do not obstruct it.
1
4
2
3
Latch
Right Wing
Bracket
Left Wing
Bracket