Propane natural – Harman Stove Company 828i User Manual

Page 8

Advertising
background image

8

INSERT TO A GAS SUPPLY

Burn Only the Fuel for Which the Heater is Equipped

The Clarity Fireplace Insert will burn either

natural gas or propane, but requires a dedicated
burner system module for either fuel. The label on
the burner system module indicates the fuel for
which it is equipped.

Making The Connection

The gas inlet is located at the bottom right rear of

the Insert. The inlet fitting
is a 1/4" male pipe
thread.

A separate gas shut-off

valve and a 1/8" N.P.T.
plugged tapping should
be installed immediately
upstream of the connec-
tion to the appliance.

The ClarityFireplace

Insert must be discon-
nected from the gas supply piping during any
pressure testing of that system at pressures in
excess of 1/2 psig (3.5 kPa).

The Clarity gas control valve must be in the OFF

position during any pressure testing of the gas
supply system at pressures equal to or less than
1/2 psig (3.5 kPa).

WARNING: To avoid pipe compounds from

entering into the gas train, apply compounds
only to the male pipe threads and only to the first
two threads.

CAUTION: TEST ALL JOINTS FOR LEAKS

PROPANE

NATURAL

Inlet

Log Positions When Assembled

Install the center log so that it goes all the way to

the back and is centered. When properly posi-
tioned, there should be an even gap along the front
of the center burner in the cavity in the log. A
small portion of the log support frame will be
revealed. The center log has a round viewing port
in the left end through which the pilot can be
observed.

Install the cross log, making sure that it is ori-

ented with the forked end toward the left rear of
the stove, and slip it over the front locator pin and
position as shown below.

Re-install and Secure the Glass door

NOTE: The glass door is heavy. Lift it carefully to

prevent damage. Center the glass on the opening
and suspend it in place by placing the tab hooks
over the top edge of the opening. Press the glass
slightly against the stove to confirm that it seats
properly, then press it firmly against the front
while pushing the levers to the rear to engage
them.

Evaluation notes were added to the output document. To get rid of these notes, please order your copy of ePrint IV now.

Advertising