Hand Held Products 4600g - Manual (Page 171)

4600g, 4600r, 4800i User’s Guide 11 - 1
11
Utilities
To Add a Test Code I.D. Prefix to All Symbologies
This selection allows you to turn on transmission of a Code I.D. before the
decoded symbology. (See the Symbology Chart, included in the
Appendix
A , page A-1) for the single character code that identifies each symbology.) This
action first clears all current prefixes, then programs a Code I.D. prefix for all
symbologies. This is a temporary setting that will be removed when the unit is
power cycled.
Show Decoder Revision
Scan the bar code below to output the decoder revision.
Note: You may use the Show Decoder Revision option if you have firmware with
a base number of 31205480. Refer to Show Software Revision on page
11-2 for information on determining the firmware revision in your unit.
Show Engine Revision
Note: You may use the Show Engine Revision option if you have firmware with
a base number of 31205480.
Scan the bar code below to output the engine revision. If your imager has an
4X00 engine, it will return an [ACK] with no data in the string. If your imager has
an 5X00 engine, it will return the engine type, revision number, and status
character [ACK]. For example, an imager with an 5100, version 26 would return:
ENGREVType: 1 Revision: 26[ACK]
Add Code I.D. Prefix to
All Symbologies (Temporary)
Show Decoder Revision
Show Engine Revision