Connecting the imager with rs-232 serial port, Connecting the imager with rs-232 serial port -7 – Hand Held Products 4600g User Manual
Page 22
Advertising
1 - 6
4600g, 4600r, 4800i User’s Guide
Connecting the Imager with RS-232 Serial Port
Note: See
on page 1-2 to determine which interfaces apply to
your imager.
1. Turn off power to the terminal/computer.
2. Connect the appropriate interface cable to the imager.
Note: For the imager to work properly, you must have the correct cable for your
type of terminal/computer.
3. Plug the serial connector into the serial port on your computer. Tighten the
two screws to secure the connector to the port.
4. Plug the power supply into the cable.
5. Once the imager has been fully connected, power up the computer.
6. Program the imager for an RS-232 Serial Port interface using the Plug and
Play bar code on
.
Advertising