haier HBE18 - Manual (Page 11)

English
10
Reinstallation: (see fig. #5 and #6)
1. Press and pull out the hinge cover from the hinge.
2. Before dismantling the lower hinge, remove the hinge axle and fix it
on the opposite hole. As shown in fig.5, dismantle the lower hinge,
and then install them on the left side.
3. Remove the door stop plate from the bottom of the door and put it on
the opposite side of the door.
4. Install freezer door: make the left bottom hole of the freezer
compartment door fall over the lower hinge axle, move back and
forward the door to make it straight and in alignment with central
hinge. Install the central hinge again, turn the hinge axle until it
completely enters the door body, and then fix it with screws.
5. As shown in fig. 6, install the central hinge and pad to the left side.
6. Install refrigerator door: make the left bottom hole of refrigerator
door fall over the central axle; raise upper hinge, so that hinge axle
can be installed in the upper hole of the upper part of the refrigera-
tor door; adjust door to make it straight and level. Tighten the screws
of upper hinge.
7. As shown in fig.3, install the upper refrigerator hinge to the left
corresponding side.
8. Replace the hinge cover as shown in fig.3.