Honeywell HEGS5001 - Manual (Page 24)

4.2 NAVIGATING THE MENUS, CONTINUED
• To exit the System Menu, use the joystick to choose menu 8 (Exit), then press
Enter ( ) or “Zoom Out” until the setup menu is exited. When you exit a
menu, the controller displays Saving Settings, Please Wait. After the settings
have been saved, the controller returns to normal operation.
4.3 MENUS
Multiplexers
Menu Name Menu
Number
Description
Mux’s 1.0 Used to set the type of multiplexer and the number of
multiplexers in the system. Press Enter (
) to access
this menu.
Mux type 1.1 Type of Multiplexers – only one type of multiplexer per
system (KX16xxCX, KQ7300Cx, KX04xxCx, KX09xxCx,
KXR23xxU, KX1630CU, MXXD9E, MXXD16E supported).
Note: Use KX16xxCX, KX04xxCx, or KX09xxCx for
KX16xxMX, KX04xxMx, or KX09xxMx respectively. For
AXCD, AXMD, HXCT, or HXMT series multiplexers, use
MXXD9E or MXXD16E depending on the number of
channels (9 or 16).
Press Enter (
).
No. of Muxes 1.2 Number of Multiplexers – 1 to 16 allowed. Each
multiplexer must have the address set at its logical
number. Press Enter (
).
Recorders
Menu Name Menu
Number
Description
Recorders 2.0 Used to set the type of VCR and the number of VCR’s in
the system. Press Enter (
) to access this menu.
VCR Type 2.1 Type of VCR – Only one type of VCR per system
(KR4xxxCx). Press Enter (
).
No. of VCRs 2.2 Number of VCR’s – 1 to 16 allowed -each VCR must
have the address set at its logical number. Press Enter
(
) or joystick tilt down to move to the next submenu.
Press Clear/Manual ( ) to exit this menu.
Rev. 1.01
14 900.0800
19-Jun-06