Honeywell HEGS5001 - Manual (Page 43)

5.2.8 List VectorScan Contents, Continued
5. When finished viewing the VectorScan contents, press Enter ( .
6. To exit the menu on the LCD controller, press Dome Menu (
1. ___
3. ___ ) or press the
Menu Esc (
1. ____
2. ____
3. ____
) key until the LCD display is cleared of all menus.
5.2.9 Program a Tour
Note: Tour Programming is only available to Master users.
1. Press the Dome Menu (
1. ___
3. ___ ) key.
2. Press + or – until Tour Menu is displayed on the controller LCD.
3. Press Enter ( ).
4. Press + or – until Program is displayed on the controller LCD.
5. Enter the Tour number (1-3) you desire to program using the numeric keypad on
the controller and press Enter ( ). The controller LCD displays:
Tour Prgm Stop
< Tour Menu >
6. The scan will begin to count down from 120 to 0 seconds. Perform the desired pan,
tilt, and zoom commands until the unit times out. The scan saves all commands as
the operator performs them. To end the programming before the scan times out,
press Enter (Tour Prgm Stop) or press the Clear/Manual (
) key.
A message PROGRAM PTZ TOUR COMPLETE is displayed on the monitor.
5.2.10 Run a Tour
1. Press the Dome Menu (
1. ___
3. ___ ) key.
2. Press + or – until Tour Menu is displayed and press Enter ( ).
3. Press + or – until Run is displayed and press Enter ( ).
4. Enter the desired tour # (1-3) using the numeric keys and press Enter ( ). The
programmed tour begins and runs continuously until the KD6/HD6 receives another
command.
Rev. 1.01
33 900.0800
19-Jun-06