Honeywell HEGS5001 - Manual (Page 48)

5.2.13.1 Programming/Editing/Deleting Privacy Zones, Sony Camera, Continued
12. Press + or – until the character for the desired action is displayed on the LCD and
then press Character Select (
ABC
).
To save Privacy coordinates, press + or – until S is displayed on the LCD and
press Character Select (
ABC
). Refer to the diagram below for programming
coordinates.
Right pan
Top tilt
Bottom tilt
Left pan
a. Using the joystick, move the PTZ so the lower left corner of the privacy zone is
on the lower left corner of the monitor, and then press Enter ( ).
b. Using the joystick, move the PTZ so the upper right corner of the privacy zone is
on the upper right corner of the monitor, and then press Enter ( ).
If the upper right tilt position is below the lower left tilt position, the message
“Illegal Tilt Direction” is displayed. Readjust the tilt position until the message
disappears or press Clear/Manual to cancel the operation and return to manual
operation.
The privacy zone is programmed for all points between the selected coordinates as
shown in the above diagram.
13. Repeat steps 9-12 to continue programming privacy zones or press Clear/Manual to
return to manual operation.
14. Press Dome Menu (
1. ___
3. ___
) to exit the Dome Menu.
Rev. 1.01
38 900.0800
19-Jun-06