Honeywell HEGS5001 - Manual (Page 51)

5.2.13.3 Changing the Privacy Zone Password
1. Press the Dome Menu (
1. ___
3. ___ ) key.
2. Press + or – until Sector/Priv Menu is displayed on the LCD.
3. Press Enter ( ).
4. Press + or – until P is displayed on the LCD and press Char Select.
5. Enter the current password.
a. Press the + or – key until the desired character is displayed on the LCD screen,
and then press Character Select (
ABC
). The controller sends the character to
the KD6/HD6.
b. Continue selecting characters and pressing Character Select (
ABC
) until all
the characters in the password have been sent to the KD6/HD6. The characters
will appear as astericks (*) on the monitor display for security purposes.
c. Press Enter ( ).
6. Press + or – until P is displayed on the controller LCD and press Character Select
(
ABC
).
7. Enter the new password. Refer to step 5, steps a through c, for entering
passwords.
8. Re-enter the new password for verification. Refer to step 5, steps a through c. If
you enter a different password the second time, an invalid message is displayed and
you must start again.
9. After programming the password, you can program a privacy zone or press
Clear/Manual ( ) twice to exit programming.
Rev. 1.01
41 900.0800
19-Jun-06