Honeywell HEGS5001 - Manual (Page 50)

5.2.13.2 Programming/Editing/Deleting Privacy Zones, Hitachi Camera, Continued
c. Press Enter ( ).
The following options are displayed on the monitor:
E to Edit the Title Press + or – key until E is displayed on
LCD and press Char Select. Repeat step
10.
D to Delete Zone
Coordinates Press + or – key until D is displayed on
LCD and press Char Select. The
coordinates for the Privacy # entered in
step 9 is deleted.
S to Program Zone
Coordinates
Press + or – until S is displayed on LCD
and press Char Select. Refer to the
instructions below in step 13.
N to Save privacy title only Press + or – key until N is displayed on
LCD and press Char Select. This option is
used for renaming Privacy Zone Titles. The
title only entered in step 11 is saved for the
Privacy # entered. The programmed
privacy coordinates are not changed.
12. Press + or – until the character for the desired action is displayed on the LCD and
then press Character Select (
ABC
).
13. If you selected S to program zone coordinates, use the joystick to move the block
over the area to be hidden. Use the left, right, up, and down arrows below the LCD
to increase or decrease the width and height, respectively, of the privacy block.
Note: the zoom function is disabled while programming a privacy zone.
14. Press Enter ( ).
15. Repeat steps 9-14 to continue programming privacy zones or press Clear/Manual
( ) twice to return to manual operation.
16. Press Dome Menu (
1. ___
3. ___ ) to exit menus on the LCD.
Rev. 1.01
40 900.0800
19-Jun-06