Honeywell HD4UX - Manual (Page 13)

Document 800-00031 Rev A 13
04/08
Connecting the Wiring
Follow Figure 5 to connect the video and power wires.
Figure 5 Wiring Connection
Adjusting the Camera
To adjust the HD4U/X Camera:
1. Apply 12 VDC or 24 VAC power to the camera and monitor the video signal.
2. Loosen the screws that lock the gimbal assembly in place (see Figure 6 ).
3. Adjust the camera carrier to the desired view.
4. Tighten the screws to lock the gimbal assembly in place.
Note Orient the camera as shown in Figure 6 to maintain the correct picture orientation.
Red+
Black –
Power
Video: female BNC
Note For secure installations,
surface-mounted cables should
be protected by plastic or metal
cable covers.