Honeywell DN 10DY - Manual (Page 14)

14
REMOVAL AND INSTALLATION METHOD OF BATTERY
⅜ How to remove the battery.
Hold the handle tight.
Press the latch located at the front of the battery
and pull out the battery. (Fig. 9)
⅜ How to install the battery.
Position the battery so that the latch faces toward
the switch trigger in the handle and insert the
battery. (Fig. 9)
CHARGING METHOD
NOTE:
Before plugging into the receptacle, make sure the
following points.
⅜ The power source voltage is stated on the name-
plate.
⅜ The cord is not damaged.
WARNING:
Do not charge at voltage higher than indicated on
the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn up.
1. Insert the plug of battery charger into the
receptacle.
When the plug of battery charger has been in-
serted into the receptacle, pilot lamp will blink in
red. (At 1-second intervals.)
WARNING:
Do not use the electrical cord if damaged.
Have it repaired immediately.
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as shown
in Fig. 10.
Make sure it contacts the bottom of the battery
charger.
Handle
Battery
Latch
Pull Out
Battery
Nameplate
Pilot Lamp
Ventilation Slots
< UC12Y >
< UC14YF / UC14YF2 >
Fig. 10
Battery
Nameplate
Pilot Lamp
Push
Insert
Fig. 9