HONDA Outboard Motor BF75A - Manual (Page 60)

Exposed moving parts can
cause injury.
Do not operate the
outboard motor without
the engine cover.
Use extreme care when
installing the engine
cover.
58
STOPPING THE ENGINE
Emergency Engine Stopping
OPERATION
SWITCH CLIP
PULL
LANYARD
EMERGENCY STOP SWITCH
EMERGENCY STOP SWITCH
SWITCH
CLIP
PULL
LANYARD
Tiller-Handle Type
Side-Mount Type
If the choke and fast idle control(s)
was used to start the engine, return
the control(s) to the normal
operating position as the engine
warms up.
During the warm-up period, check
the oil pressure indicator (p.
),
overheating indicator (p. ), and
cooling system indicator (p. ).
Leave the recoil starter assembly
off, but install the engine cover (p.
), and lock it in place by
latching the engine cover latch.
If it was necessary to remove the
emergency stop switch lanyard
from your wrist to perform the
emergency starting procedure, be
sure the lanyard is attached to your
wrist before operating the
outboard motor.
Have your closest authorized
Honda marine dealer check your
electrical system and correct the
problem, so you can use the
electric starter.
The recoil starter assembly (p. )
should be reinstalled after the
electric starter is working again.
Install the recoil starter assembly
with the engine stopped.
6.
7.
8.
9.
35
36
37
32
57
02/03/25 21:25:22 31ZW0601_059