HoMedics BPA-100 - Manual (Page 7)

12 11
Connect AC
adapter here
AC Adapter
Input: 120V 60Hz 15W
Output: 12V DC 600mA
INSTALLING BATTERIES
1. Press down on latch and lift the battery cover
towards you to open the battery compartment.
2. Install or replace 4 “AA” sized batteries in the
battery compartment according to the indications
inside the compartment.
3. Replace the battery cover by clicking in the
bottom hooks first, then push in the top end
of the battery door.
Replace the batteries if:
1. The weak battery symbol appears on the display.
2. Nothing appears on the display when the power is
switched on.
As the supplied batteries are for test only, they may be
discharged earlier than batteries you buy in stores.
Replace the batteries in pairs. Remove batteries when
unit is not in use for extended periods of time.
Note: Batteries are hazardous waste. Do not dispose
of them together with the household garbage.
USING AN AC ADAPTER (NOT INCLUDED)
This monitor is designed for operation with batteries or
an optional AC adapter. Please use only a compatible,
UL approved AC adapter with required voltage and
current as indicated in this manual. Contact HoMedics
Consumer Relations at 1-800-466-3342 to purchase a
compatible AC adapter.
Note: • Please unload the batteries when operating
with an AC adapter for an extended period
of time. Leaving the batteries in the compartment
for a long time may cause leakage, which
may lead to damage of the unit.
• No batteries are needed when operating
with an AC adapter.
Connect the AC adapter with the AC adapter jack
in the back of the unit as shown below.
BPA-100IB_ENGSP.qxd 10/24/05 10:51 AM Page 11