Figure 7 library controller board connections, Factory-defined accessory pci slots, 7 library controller board connections – HP MSL6000 Series User Manual
Page 25
MSL6000 series tape library user guide
25
NOTE:
For MSL Series libraries, the library controller board must be installed in the right-hand slot
of the card cage area (upper card cage area for the four-drive models). The remaining slots on the
library do not support the connections that are required for the library controller board to operate
correctly.
.
Figure 7
Library controller board connections
NOTE:
The mode toggle switch is not active.
Factory-Defined Accessory PCI Slots
MSL Series tape libraries contain one or two rear-access card cages, and one or two 32-bit,
33-MHz Compact PCI backplanes (see
). These backplanes contain the plug-in connectors
for a library controller board, and up to five optional HP-defined PCI add-in cards.
CAUTION:
Use of non-HP qualified PCI option cards can damage your MSL Series library and will
void product warranty. Follow all operating instructions shipped with the optional card upgrade kit.
1
SCSI VHDCI connector
2
SCSI VHDCI connector
3
Mode toggle switch
4
Ethernet RJ-45 connector
5
Serial RS232 connector