Setting up the rackmount model – HP MSL6000 Series User Manual
Page 30
Installation
30
Figure 11
Converting a tabletop model (four-drive model shown)
Setting Up the Rackmount Model
WARNING!
To reduce the risk of personal injury or damage to the equipment, be sure that:
•
The leveling jacks are extended to the floor.
•
The full weight of the rack rests on the leveling jacks.
•
In single rack installations, the stabilizing feet are attached to the rack.
•
In multiple rack installations, the racks are coupled.
•
Only one rack component is extended at any time. A rack may become unstable if more than
one rack component is extended for any reason.
Setting up the rackmount model requires a template, rack enclosure slide rails, and two people or a
mechanical lift to physically install the library in a rack enclosure.
To set up the rackmount model:
1.
Use the template that shipped with the library to mark the location of the mounting hardware on
the mounting rails of the rack enclosure (see
). The black dots along the sides of the
template indicate the top of a U.