Honeywell XENON 1902 - Manual (Page 134)

6 - 4
Data Format Editor Commands
Send Commands
Send all characters
F1 Include in the output message all of the characters from the input
message, starting from current cursor position, followed by an insert
character.
Syntax = F1xx where xx stands for the insert character’s hex
value for its ASCII code.
Refer to the
ASCII Conversion Chart (Code Page 1252), beginning on
page A-4 for decimal, hex and character codes.
Send a number of characters
F2 Include in the output message a number of characters followed by an
insert character. Start from the current cursor position and continue for
“nn” characters or through the last character in the input message,
followed by character “xx.”
Syntax = F2nnxx where nn stands for the
numeric value (00-99) for the number of characters, and xx stands for
the the insert character’s hex value for its ASCII code.
Refer to the
ASCII Conversion Chart (Code Page 1252), beginning on
page A-4 for decimal, hex and character codes.
Send all characters up to a particular character
F3 Include in the output message all characters from the input message,
starting with the character at the current cursor position and continuing
to, but not including, the search character “ss,” followed by an insert
character. The cursor is moved forward to the “ss” character.
Syntax
= F3ssxx where ss stands for the search character’s hex value for its
Terminal ID Table
Terminal Model(s)
Terminal
ID
IBM PC/AT and compatibles 003
USB SurePOS Handheld
Scanner 128
USB SurePOS Tabletop
Scanner 129
RS232 True 000
TTL 000
RS485 051
USB Serial 130
PC Keyboard 124
Mac Keyboard 125
Japanese Keyboard (PC) 134
HID POS 131