Honeywell XENON 1902 - Manual (Page 139)

6 - 9
Check for non-numeric character
ED Check to make sure there is a non-numeric ASCII character at the
current cursor position. The format is aborted if the character is
numeric.
Insert a delay
EF Inserts a delay of up to 49,995 milliseconds (in multiples of 5), starting
from the current cursor position. Syntax = EFnnnn where nnnn stands
for the delay in 5ms increments, up to 9999. This command can only
be used with keyboard wedge interfaces.
Discard Data
B8 Discards types of data. For example, you may want to discard Code
128 bar codes that begin with the letter A. In step 4 ( page 6-2 ), select
6A (for Code 128), and in step 5, select 9999 (for all lengths). Enter
B8FE41 to compare and discard Code 128 bar codes that begin with
the letter A.
Syntax = B8.
Note: Other data format settings impact the B8 command. If Data Format
Non-Match Error Tone is On ( page 6-11 ), the scanner emits an error
tone. If Data format Non-Match Error Tone is Off, the code is
disabled for reading and no tone is sounded. If Data Format is On,
but Not Required (
page 6-10 ), bar code data that meets the B8
format is scanned and output as usual.
Data Formatter
When Data Formatter is turned Off, the bar code data is output to the host as
read, including prefixes and suffixes.
You may wish to require the data to conform to a data format you have created
and saved. The following settings can be applied to your data format:
Data Formatter On, Not Required, Keep Prefix/Suffix
Scanned data is modified according to your data format, and prefixes and
suffixes are transmitted.
Data Formatter On, Not Required, Drop Prefix/Suffix
Scanned data is modified according to your data format. If a data format is
found for a particular symbol, those prefixes and suffixes are not
transmitted. If a data format is
not found for that symbol, the prefixes and
suffixes are transmitted.
Data Formatter Off